Daxys Lizard Flat Bar Commuter 26”

The Daxys Lizard is an ebike in the traditional, flat bar shape with a single gear.

From $1,399.00

DISCLAIMER AROUND SPEED AND RANGE
THE PRODUCT WAS TESTED FULLY CHARGED, WITH AN AVERAGE LOAD OF 75KG-85KG, AT A NORMAL TEMPERATURE ON A NORMAL PAVED ROAD BETWEEN THE SPEEDS OF 0-25KM/H. THE RESULTS MAY VARY BASED ON DIFFERENCES IN TEMPERATURE, LOAD, WIND SPEED, ROAD CONDITIONS AND OTHER FACTORS.

PLEASE NOTE:
EACH STATE AND TERRITORY IN AUSTRALIA HAS A DIFFERENT SET OF RULES AND REGULATIONS PERTAINING TO THE USAGE OF E-SCOOTERS, E-BIKES AND E-BOARDS (INCLUDING WHERE E-SCOOTERS, E-BIKES AND E-BOARDS CAN LEGALLY BE USED AND WHETHER E-SCOOTERS, E-BIKES AND E-BOARDS NEED TO BE REGISTERED WITH THE RELEVANT ROAD TRAFFIC AUTHORITY).  ANY USER OF THIS PRODUCT MUST ENSURE THAT THAT THEY CHECK AND ABIDE BY THEIR LOCAL BY-LAWS AND USE RESPONSIBLY.  RIDE WITH CAUTION AND ALWAYS WEAR A HELMET AND PROTECTIVE GEAR WHEN RIDING YOUR E-SCOOTER, E-BIKE AND E-BOARD. BEFORE RIDING YOUR E-BIKE, E-SCOOTER AND E-BOARD ENSURE THE BOLTS ARE TIGHT AND THE BATTERY IS CHARGED.

CAUTION:
DANGER MAY OCCUR WHEN THE KICKSTAND IS ACCIDENTALLY KNOCKED DOWN OR CATCHES OBJECTS IN COMPLEX TERRAINS.
DISMOUNT YOUR KICKSTAND BEFORE TRAIL RIDING!

Please Note: Modifications, alterations and installation of parts that are not Sur-ron parts or supplied as original equipment are not covered by warranty. Sur-ron will not take any responsibilities for any problems arising from modifications, alterations or aftermarket replacement on the following parts (including but not limited to): battery, motor, controller, throttle, transmission system, suspension system and brake system etc.

Following is the potential risk that may be cause by the above modifications:

  1. Modified controller: It may cause the bike system failure, battery discharge failure, motor overheating and demagnetization, loss of various diagnostic and protection functions.
  2. Modified battery: it may cause the controller failure, motor malfunctions. It may even cause serious injury or damage property.

Any power system modification that has not been authorised by Sur-ron may cause wheelset failure, transmission system overload, brake system overload and even bike frame failure.

Designed for ease of use and convenience – Spend more time ‘laxing like a lizard as you reach your destination early and easily.

NOTICE TO CUSTOMERS: Please carefully follow instructions when installing the pedals on this e-bike. There are specific right and left pedals for each side and installing them incorrectly will result in damage to the bike.

Please Note: Each state and territory in Australia has a different set of rules and regulations pertaining to the usage of e-scooters, e-bikes and e-boards (including where e-scooters, e-bikes and e-boards can legally be used and whether e-scooters, e-bikes and e-boards need to be registered with the relevant road traffic authority). Any user of this product must ensure that they check and abide by their local by-laws and use responsibly. Ride with caution and always wear a helmet and protective gear when riding your e-scooter or e-bike.

Specification
Product Size
1040*640*1800mm
Product Weight (kg)
24.4kg
Packaging Size (mm)
760*235*1600mm
Packaging Weight (kg)
32.2kg
Max weight bearing (kg)
120kg
Recommended rider age
16 years and over
Recommended rider height (cm)
175-190cm
Top speed (km/h)
25
Approx. range (km)
25-40
Battery charge life
800 Cycles
On-road / Off-road
On-road
Traversable terrain
Short grass, dirt, gravel and paved road
Max. incline (degrees)
N.A. for Bikes - refer to torque - 42N.M
Operating temperature range (C)
-10-50 C°
Storage temperature range (C)
-10-50 C°
IP rating
IP65 for Display
Waterproof
No
Water Resistant
Yes
Tyre type
Clincher tyres with inner tube
Tyre size (inches)
26x2.125"
Braking method
Mechanical disc brakes
Braking distance (metres)
3
Frame material
Iron
Remote Control(s)
No
Time to full charge
3-4 hours
Battery nominal voltage
36v
Max. charging voltage
42v
Nominal energy (Wh)
270Wh
Battery capacity (mAh)
7.5Ah
Riding modes
Pedal assist mode (PAS) 0-3 + walk assist mode
Motor max. power (watts)
350W
Motor nominal power (watts)
250W
Charger output power (watts)
84W
Charger input voltage
100-240V
Charger output voltage
42V
Charger output current (amps)
2.0A Max
Manufacturer's warranty
1 Year
Brand

Product FAQ’s

Q: How many pedal assistance modes does the Lizard have and how do I change between them. Can I change modes while riding?
A: Lizard has three pedal assistance modes. Press the MODE button located left integrated controller to switch between PAS 0-3. Modes can be changed while riding.

Q: How do I operate the lights? Where are the lights located?
A: Long press the + button located left integrated controller to operate the lights. There is one headlight & one taillight.

Q: How do I power Lizard on/off?
A: Press the ON / OFF button located left integrated controller to operate the lights.

Q: What type of terrain is Lizard appropriate for?
A: Suggestions are outlined below:
1: Regular paved surface where the tyres can maintain ground contact. Low slopes.
2: Unpaved and gravel roads. Reasonably smooth off-road trails. Medium slopes.

Q: What is the target rider/audience for this product?
A: Usage: Daily on-road commuting. Recommended rider height: 170-195cm

Q: Does the bike/scooter require tools for assembly or are they included? Will I need help assembling it?
A: The Lizard included a multi-function tool to help you assemble it. You will feel more comfortable if you have a wrench when you are installing the pedals. It’s recommended to assemble it with 2 people.

Q: What is the recommended tyre pressure for Lizard?
A: The recommended tyre pressure is 40-60 (max) PSI

Q: Can I ride my Lizard in the rain?
A: Although your Lizard can withstand rainy days, it is recommended to minimize exposure to rain when possible and to store your product under a roof.

Q: Can I adjust the handlebar height?
A: Yes.

Q: There are multiple brakes, when should I use each? (May not apply to all products)
A: Generally, the proper braking technique is applying the rear brake, followed by the front brake. When releasing the brakes, release the front brake first, followed by the rear.

Q: What tools will I need to tighten loose screws?
A: The Lizard included a multi-function tool to help you tighten loose screws

Q: When will pedal assistance kick in?
A: Pedal assistance will start when the power and PAS mode is turned on and you begin pedalling

Q: Does this Product come with app connectivity?
A: No.

Q: Can I ride this in any temperature – what is the operating temperature range?
A: The recommended operating temperature is -10 – 50°C

Q: Does the product need any special regular care, storage etc?
A: When you remove the battery to store it, make sure it is in a safe, climate-controlled space. If the bike is not used for a longer period, it is best to remove the battery from the bike. Charge when needed, at least every 3 months.
When charging the battery, make sure it is in a dry location and be sure it’s in a place where it won’t cause a fire.

Q: Can I take my electric bike over jumps or off high drops?
A: No, Lizard is not designed for taking over jumps and taking off high drops.

Choose a retailer: